LQ-670 Service Manual
Figure 3-11. Cable Rooting
3.2.10 PW Detector (Top) Removal
1. Remove [HOUSING, UPPER] (See Section 3.2.1)
2. Remove the Printhead (See Section 3.2.6)
3. Remove the Paper Exit Assy. (See Section 3.2.8)
4. Remove the Ribbon Mask Holder (See Section 3.2.9)
5. Remove one screw (CB/M2.5x6) fixing the PW Detector (Top) and remove it.
CAUTION
When you fixing the PW Detector (Top) to the Ribbon Mask Holder, be careful not to
damage a screw hole on the Ribbon Mask Holder.
Tightening Torque: 0.1±0.02Nm (1.0±0.2Kgf-cm)
Figure 3-12. PW DETECTOR Removal
3-14
Rev. A