LQ-670 Service Manual
3.2 Printer Disassembly and Assembly
This section describes procedures for disassembling the main components of the printer.
Since re-assembling the printer can be done by simply performing the disassembly
procedures in reverse order, this chapter does not describe the assembly procedures. If
necessary, special notes on re-assembling or adjusting a component are given at the end of
each procedure.
Before disassembling any part of the printer, note the warnings in Section 3.1.1.
Make sure to remove any cables and the accessories attached to the printer; such
as the ribbon cartridge, the sheet guide, the platen knob, from the printer before
disassembly.
Note) Exploded diagrams in APPENDIX show you how each component fit together. Refer
to them as necessary.
The flowchart below show you the basic order for disassembly.
3-4
CAUTION
Figure 3-1. Disassembly Flowchart
Rev. A