Motor, Cr Removal - Epson LQ-670 Service Manual

3.2.11 MOTOR, CR Removal

1. Remove the Printer Mechanism (See Section 3.2.2)
2. Unhook the cable of [MOTOR, CR] from a cable hook at the bottom of the Printer
Mechanism.
3. Remove [TENSION SPRING, 14.5] attached at the top right of the Printer Mechanism, to
loosen the timing belt.
4. Remove four screws (CBS/M3x6) fixing the CR motor assembly to the Printer Mechanism,
and remove it.
5. Remove two screws (CBS/M3x6) and remove [MOTOR, CR] from [MOUNTING PLATE,
MOTOR, CR].
Bi-D Alignment Adjustment (See Chapter 4 Adjustment)
Rev. A
REQUIRED ADJUSTMENT
Figure 3-13. MOTOR, CR Removal
Chapter 3 Disassembly and Assembly
3-15