Lever, Release Removal - Epson LQ-670 Service Manual

3.2.21 LEVER, RELEASE Removal

1. Remove the Printer Mechanism (See Section 3.2.2)
2. Remove two E-shaped retaining rings (#4) that fixing [LEVER, RELEASE] to [FRAME
ASSY., RIGHT].
3. Remove [LEVER, RELEASE] from [FRAME ASSY., RIGHT], together with
[COMBINATION GEAR, 16, 16].
Be careful not to lose [GEAR, 20] and a washer when removing [LEVER, RELEASE]
as they may be popped out by [COMPRESSION SPRING, 20].
Make sure that [GEAR, 20] moves smoothly when moving [LEVER, RELEASE].
Make sure to match the position marking on [LEVER, RELEASE] and
[COMBINATION GEAR, 16, 16], as shown in figure below, when reinstalling
[LEVER, RELEASE].
Rev. A
CHECK POINT
Figure 3-28. LEVER, RELEASE Removal
Figure 3-29. LEVER, RELEASE Installation
Chapter 3 Disassembly and Assembly
F
F T
3-27