Switches - Epson LQ-670 Service Manual

LQ-670 Service Manual

1.4.1.2 Switches

‰Operation in normal mode
In normal mode, pressing panel switches executes following function.
Switch
Operate
Pause
Load/Eject
LF/FF
Tear Off/Bin
Font
Condensed
‰Operation at power on
Turning the printer on while pressing panel switches executes the function shown below.
Load/Eject
LF/FF
Font
Load/Eject & LF/FF
Condensed &Tear Off/Bin
Pause
Font & Condensed
The others
‰Operation in default setting mode
The switches are used in default setting mode as follows:
Font
Tear Off/ Bin
The others
1-24
Table 1-23. Operation in Normal Mode
Turn the printer on and off.
Alternates printing and no-printing status.
Enables Micro Adjust function, holding it down for 3 seconds.
Loads or ejects the paper.
Executes micro feed forward, when this function is enabled.
Executes line feed, pressing it shortly.
Executes form feed, holding it down for a few seconds.
Executes micro feed backward, when this function is enabled.
Advances continuos paper to the Tear-off position.
Selects CSF bin ½ or Card mode.
Selects font.
Alternates condensed mode and non-condensed mode.
Table 1-24. Operation in Power On
Switch
Table 1-25. Operation at Default Setting Mode
Switch
Selects the Menu
Changes the setting
Not available
Function
Function
LQ self test
Draft self test
Default setting
Data dump
Clear EEPROM
Bi-d adjustment
Quiet mode
Not available
Function
Rev. A