Epson LQ-670 Service Manual page 92

LQ-670 Service Manual
9. In this menu, Select 106 column by moving the cursor with the or
After the selection is made, the following menu is displayed.
10. In this menu, select FF paper by moving the cursor with the or
Perform the test printing for one sheet of the continuous paper.
11. After setting, go to Bi-D adjustment or complete the program regularly and turn off the printer.
; Since the setting values are registered in EEPROM of the main board after the test printing, make
sure to perform test printing after adjustment program is completed.
; If the wrong destination is input, the correct printer performance can not be guaranteed.
; Since this printer uses the secondary switching and AC voltage is charged on the primary side,
make sure to plug off the AC cable when you pull in or out the interface.
; Since GWBASIC system and all other necessary files are included in the disk of the adjustment
program, load from the disk when you perform adjustment.
; In the adjustment program, other items which is not necessary for this adjustment are also
included. However, we can not guarantee the normal printer operation if the item, which is not on
the manual, is selected.
4-4
CAUTION
and press ENTER key.
and press ENTER key.
Rev. A