Motor Pulley; Stand Table Top; Assembly Of The Stand Frame And Height Setting - Duerkopp Adler 528 Instruction Manual

Motors are to be chosen according to the following table:
Machine Ordered
subclass number
S359 600030 88
101 S359 600030 75
S359 600030 58
S359 600045 810 Stopmotor EFKA
S359 600045 820 DC 1600/DA82GA
105 S359 600052 88
S359 600052 75
S359 600052 58
* Control panel S359 600038/V810 or S359 600050/V820 it is possible to order for setting the stop motor, however, it is
not included in supply of the stopmotor and it has to be ordered separately.
The given stop motors have been tested on the machine and comply with the functional requirements. Other types of
stop motors may or may not have suitable parameters.The manufacturer thereof does not recommend any use of
different stop motor without having tested it.

2.4 Motor pulley

By stopmotor EFKA DC 1600/DA82GA is revolutions are set continuously by electronics.
The pulley for the maximum or other sewing speed will be supplied on express wish of the customer.
The pulley are to be chosen according to the following table:
Motor
FIR 1148/552/3
EFKA VD552
2
Name
FIR 1148
3 x 400/230 V, 50/60 Hz
1 x 230 V, 50/60 Hz
Stopmotor EFKA
VD 552/6F82FA
3 x 400/230 V, 50/60 Hz
Sewing speed Sewing speed ø of pulley
50 Hz 60 Hz
1810 2170
2020 2430
2150 2580
2330 2790
2500 3000
2710 3260
2890 3460
3020 3620
3230 3880
3450 4140
3660 4400
3790 -
3880 -
4310 -
Fig. 1
ø of pulley
Machine rev. Approx. specification
mm max./min
88 3800 asynchronous bipolar clutch motor
75 3200 switch-circuit breaker with cabling
58 2500 connection material
58 adjustable D-C motor (A-C servo); switch-circuit breaker
58 adjustable control panel EFKA V 810/V820
connection material and cabling
88 3800 asynchronous bipolar stopmotor with friction
75 3200 clutch and brake
58 2500 switch-circuit breaker with cabling
connection material
control panel EFKA V 810/V820 *
Ordered number
mm of pulley
42 S980 045548
47 S980 045377
50 S980 045491
54 S980 045361
58 S980 045472
63 S980 045378
67 S980 045476
70 S980 045370
75 S980 045384
80 S980 045479
85 S980 045480
88 S980 045383
90 S980 045481
100 S980 045483

3. Stand table top

For the event when the customer will ensure his own stand
table top, its drawing is given on the page 4 (Fig. 5).

4. Assembly of the stand frame and height setting

2
(Fig. 1)
Proceed to the assembly of the stand frame according to
the Fig. 1. The dimension "B" is destined for a middle-
1
high stature of the machine attending person. For a higher
stature it is necessary to increase the dimension "B" and
inversely. The machine feet are to be levelled with the
floor in loosening the screws (1). Using the screws (2) it
is possible to set up the height of the stand table top.
2