Editing Mode; Altering A Step; Inserting A Step; Deleting A Step - Duerkopp Adler 550-12-23 Operating Instructions Manual

3.5 Editing Mode

3.5.1 Altering a Step

3.5.2 Inserting a Step

3.5.3 Deleting a Step

–
If the step to be altered is not shown in the display:
- Select the program to be changed.
- Select the step which is to be altered.
–
Hold the "Y" key down and tap the "P" key.
The editing mode is switched on.
The dots in the middle display blink.
–
Enter the new crimping value.
–
Hold the "Y" key down and tap the "P" key.
The altered value is stored in memory.
An additional step can be inserted in front of the displayed step.
–
If the step to be altered is not shown in the display:
- Select the program to be changed.
- Select the step which is to be altered.
–
Hold the "Y" key down and tap the "P" key.
The editing mode is switched on.
The dots in the middle display blink.
–
Hold the "Y" key down and tap the "E" key.
A step is inserted in front of the displayed step.
–
Enter the crimping value for the inserted step.
–
If the step to be deleted is not shown in the display:
- Select the program to be changed.
- Select the step which is to be deleted.
–
Hold the "Y" key down and tap the "P" key.
The editing mode is switched on.
The dots in the middle display blink.
–
Hold the "Y" key down and tap the "P" and "E" keys.
The displayed step is deleted.
15