Fan Preparation - Casablanca SIENA Owner's Manual

PERMA•LOCK™ HARDWARE (not to scale)
Uplight Lightbulbs
(4) A-15 40-watt Allen Wrench
IMPORTANT SAFETY INFORMATION:
Before starting the installation of your ceiling
fan, install the threaded downrod into the motor
coupling and lock the assembly.
Prepare for fan installation as follows:
Step 4a. Remove the caution shield from the motor.
Step 4b. Using the provided Allen wrench (attached to
the paper motor warning shield), loosen the Allen set screw
attached to the motor coupling.
Step 4c. Slide the 9" Perma•Lock
assembly through the center of the Decorative Arm
assembly.
Step 4d. Route the wires through the Perma•Lock
downrod and ball assembly.
Step 4e. Insert the downrod into the motor coupling,
turning clockwise until it stops, ensuring that the pole
has bottomed out.
TIP: The downrod has a tapered thread that is designed
to lock completely when installed correctly.
Step 4f. Tighten the set screw with the Allen wrench to
ensure safe operation of your fan. If it is tight enough, you
should not be able to turn the downrod counterclockwise
with your hands. If in doubt, tighten the set screw with
the Allen wrench until you cannot turn it any further.
Step 4g. Tighten collar screw on Decorative Arm
Assembly to secure.
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and fall
during normal operation.
NOTE: Installation of the Decorative Arm Assembly is
optional. For installations without the Decorative Arm
Assembly, a 3" downrod is provided.
6

FAN PREPARATION

Decorative Arm
Assembly
Allen Wrench
™ downrod and ball
™
9" Perma•Lock™
Downrod
and Ball Assembly
(for decorative
arm assembly
installations)
Motor Wires
(leave at least 6" long)
Decorative Arm
Assembly
Allen
Set Screw
Caution Shield
3" Perma•Lock™
Downrod
and Ball Assembly
(for non-decora-
tive arm assembly
installations)
Ground Wire
(green)
Perma•Lock™ Downrod
and Ball Assembly
Tapered thread
Motor
Coupling
Motor Housing
Assembly
3" Perma•Lock™ Downrod
and Ball Assembly
(for non-decorative arm
assembly installations)