Versa•Touch2™ Control Installation; Control Bracket Installation - Casablanca SIENA Owner's Manual

VERSA•TOUCH2™ CONTROL INSTALLATION
VERSA•TOUCH2™ HARDWARE (not to scale)
W-73
W-73
Control Holder
Control
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with
an isolating wall control/switch. CAUTION! Do not use with wall dimmer.
Step 14 Follow instructions for the type of transmitter control bracket you will be using.
Inner
mounting
holes
Control
Bracket
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided
screwdriver.
Wall Installation
Step A. Locate a 2x4
wall stud in a convenient
location.
Step B. Orient the
control bracket as shown
over the 2x4 stud.
Step C. Insert the 1"
wood screws in either
the inner or outer
mounting holes and
tighten using the
provided screwdriver.
10
Drywall Anchor
12v Battery

CONTROL BRACKET INSTALLATION

Standard
Toggle
Switch
Switch
Cover
Plate
Wood
Screw
6-32 (2) 1" (2)
Outer
mounting
holes
Control
Bracket
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step D. Insert and tighten the screws using the provided
screwdriver.
NOTE: The wall anchors and 6-32 x 1" screws may be
used in situations where mounting to a stud is not possible.
Use the inner mounting holes. After securing the anchor,
discard the anchor's pointed screws and use the 6-32 decor
ovalhead screws supplied.
Anchor
Panhead
Screw
Wood
Screw 1"
Screw Screw
6-32 X / " 6-32 X 1"
3
8
(2) (2)
Rocker
Light
Switch
Switch
Cover
Plate
Drywall Anchor
Decor Ovalhead Screw
6-32 X 1"