Bezel Replacement - Casablanca 19th Century Instructions Manual

®
IN THE WALL BEZEL REPLACEMENT
WALL CONTROL AND HARDWARE (not to scale)
Switch Mounting
Screws (2)
W-84
Wall Control
WARNING!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAUTION! NOT turning the power OFF at the
circuit breaker or fuse box may cause damage
to the electronics within the wall control and/
or the PC board on the fan.
W-84 Wall Control Bezel Replacement installation
as follows - (In the Wall Replacement):
Step 1a. Locate the two (2) screws holding the switch
plate to the wall control and remove the cover plate
as shown in Figure #1.
Step 1a. Locate the four (4) tabs holding the bezel to
the front of the switch, then press in on each tab one
at a time, removing the bezel as shown in Figure #2.
Step 1b. Locate the rubber key pad attached to the
four (4) locating pins as shown in Figure #2 and
remove rubber key pad from the WHITE bezel, also
as shown in Figure #2.
3
Switch Bezels
(1) White
(1) Almond
White Wall Almond Wall
Plate(1) Plate(1)
SCREWS
(2)
(4) Wire Cap
Wall Plate
Screws
(2) White
(2) Almond
White Wall
Figure #1
BEZEL
BEZEL
TABS
Figure #2
19