Operation - Casablanca 19th Century Instructions Manual

The button is normally left in the on position. Always turn the power off
during cleaning or servicing the fan and during thunderstorms. It is also used to
exit or enter additional programs.
The button must be left on to retain a previously set fan speed or light level.
There are six individual speed settings for the fan; each speed is indicated
by an audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled
will start rotating at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the
same speed each time the
of speed, turn the fan on by pressing
lower speed, turn fan off, then on by pressing and holding the
button until the desired speed is reached. When the fan is on, you may
increase the speed by pressing and holding the
desired speed is reached, then release it.
The direction of airflow can be changed from down-
ward to upward or from upward to downward.
To reverse the airflow:
1. Make sure the
ing.
2. Press the button.
To turn the lights off and on, press and release the
one second.
1. First press/release of the
2. Second press/release of the
3. Third press/release of the
4. Fourth press/release of the
5. Fifth press/release of the
6. Sixth press/release of the
To vary the light brightness at each touch level:
Make sure where you are in the sequence to the right.
To dim both lights at the same time:
1. Make sure you have the uplight on.
2. Turn the light off, then press and hold the
lights will come on at their lowest setting and gradually become brighter or dim-
mest level if you continue holding the
3. Release the button when the desired brightness is reached.
3
®
OPERATION POWER
OPERATION SPEED CONTROL
button is used. To maintain this level
less than one second. To
OPERATION REVERSING AIRFLOW
is on and blades are Turn-
OPERATION LIGHTS
button- Both lights shall turn ON.
button- Both lights shall turn OFF.
button – Downlight turns ON only.
button – Downlight turns OFF.
button – Uplights turns ON only.
button - Uplights turns OFF only.
button. After one second, both
button.
FAN CONTROL
ON - OFF:
A momentary
. The fan blades
press of the FAN
button
CHANGE
SPEED:
Press and hold
FAN button
longer than one
second
button until the
Note: A four-toned signal
indicates the command was
accepted by the fan. A few
seconds later the fan will slow
to a stop and then reverse
direction.
button for less than
LIGHT CONTROL
ON - OFF:
A momentary press of the
LIGHT button
CHANGE BRIGHTNESS:
PRESS AND HOLD
LIGHT BUTTON
LONGER THAN ONE
SECOND
15