Casablanca 19th Century Instructions Manual page 16

To dim just the up light:
1. Make sure you have just the downlight on.
2. Turn the light off, then press and hold the
second, the up light will come on at their lowest setting and gradually be-
come brighter or dimmest level if you continue holding the
3. Release the button when the desired brightness is reached.
To dim just the down light:
1. Make sure you have both lights on.
2. Turn the light off, then press and hold the
second, down light will come on at their lowest setting and gradually
become brighter or dimmest level if you continue holding the
ton.
3. Release the button when the desired brightness is reached.
NOTE: All fans leave the factory set to
"1111"
You will only have to change the dip switch settings in the remote if you
are using more than one fan in the same area and want to control them
separately.
NOTE: DO NOT set dip switch setting in the remote
to '0000', this may cause frequency interference from
other Casablanca Products.
Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle
switch, for the fan you want to change.
Step 2. Remove the screws and switch plate from the existing switch box.
Step 3. Remove the screws holding the switch in the switch box.
Step 4. Pull the existing W-84 switch from the switch box to expose the dip
switches located on the side of the control as shown in Figure #1.
Step 5. Change the dip switch settings, assuring that they are different from
the previously installed Inteli-Touch
Step 6. Mount the W-84 Wall Control unit back into the wall electrical box.
Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the
power off for the fan whose frequency you are changing.
Step 8. Within 20 seconds of restoring power to the ceiling fan and the W-84
Wall Control press and hold both the "FAN" and "REVERSE" buttons as
shown in Figure #2. For 3 seconds, you will hear one tone from the Piezo
Buzzer indicating the command has been accepted.
16
3
®
OPERATION LIGHTS
CHANGING FREQUENCY SETTING
3 fan.
®
button. After one
button.
button. After one
but-
DIP
SWITCHES
DIP SWITCHES
SET TO '1111'
(Factory Setting)
NOTE: Light Operation -
the light varies from "bright"
to "dim" over approximately
8 seconds. This sequence
will reverse the light when
it reaches the brightest
or dimmest level if you
continue to hold the LIGHT
button. Release the button
when the desired level is
reached.
(Figure 1)
DIP SWITCHES
SET TO '1001'
(Figure 2)