Casablanca 19th Century Instructions Manual page 3

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary to assemble and install
your Casablanca ceiling fan. These parts are shown at the
start of each installation section. Before you start, go through
this Owner's Manual and confirm that you have all the parts
shown in each section.
DOWNROD COVER
Prepare the downrod as follows:
Step A. Insert the small lip of the rubber gasket into the
downrod cover.
Step B. Slide the downrod cover, rubber gasket first, onto the
downrod by using a twisting motion. Continue until the rubber
gasket is flush with the downrod ball.
Step C. Attach the metal gasket onto the downrod assembly
as shown. Using the provided screw, secure the metal gasket.
Tighten the screw by hand only.
PREPARATION INSTRUCTIONS
GETTING STARTED
PERMA•LOCK™ HARDWARE
INSTALL RUBBER GASKET
ATTACH COVER TO DOWNROD
INSTALL METAL GASKET
19 Century
th
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 4 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap,
be careful not to scratch the blades.
RUBBER DOWNROD
GASKET
CAUTION: Do not attach the cover onto the
downrod by pounding the downrod into the
floor. This will damage the hanging mecha-
nism and may cause the fan to fall.
™
METAL DOWNROD
GASKET
DOWNROD & BALL
ASSEMBLY
3