HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual page 100

3 Pull the processor straight out of the socket.
CAUTION Handle the processor carefully. To avoid bending the processor pins, keep the processor
perfectly flat when removing and storing it.
NOTE Store the processor in a safe place where it will not be damaged.If you are permanently removing
a second processor, check your OS documentation to determine if you should change any OS settings to
disable multiprocessor support or enable Hyper-Threading support.
Replacing the Processor
1 Disconnect power from the system
heatsink (page
2 Raise the processor socket handle fully (the full swing angle of the lever is approximately 135
degrees).
CAUTION Processor pins are delicate and bend easily. Use extreme care when placing the processor in
the socket.
3 Line up the triangle on the top of the processor with the triangle on the corner of the processor socket
and install the processor into the socket. Ensure that the underside of the processor is level with the
100 REMOVAL AND REPLACEMENT PROCEDURES
(page
96), and remove the processor
66), remove the access panel
(page 99).
(page 71), remove the CPU