System Board - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

top of the processor socket. Lightly press down on the top of the processor while closing the socket
lever.
4 Check for proper processor seating in the socket by carefully trying to lift the processor out of the
socket with your fingers. A properly seated processor does not lift out of the socket.

System Board

To remove the system board:
1 Disconnect power from the system
workstation on its side with the system board facing up, remove all expansion boards and graphics
cards (page 84), and remove the CPU heatsink
2 Disconnect all cabling from the system board.
CAUTION Be sure you can differentiate which power cable was disconnected from the PCI Express x16
graphics card and which power cable was disconnected from the system board. These two cables look
very similar. The PCI Express power cable has a black connector and the power cable has a white
connector. When power is present, you must NEVER connect the PCI Express power cable to the
system board. If you do so, the system board may be damaged and your warranty voided. To see a
picture of the PCI Express cable and where it must be connected, refer to the
Installation" section on page
NOTE Make note of the cable connections before disconnecting them from the system board. Refer to
"Power Connections to Drives" section on page 87
3 Slide the system board forward
(page 66), remove the access panel
(page
84.
for more information.
1 to disengage the plastic mounting standoffs from the chassis.
(page
96).
"PCI or PCI Express
REMOVAL AND REPLACEMENT OF COMPONENTS 101
71), lay the