HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual page 109

LOG TAB
The Log tab consists of three views.
Test Log—Displays all tests that have been executed, number of times of execution, number of times
the test failed, and the time it took to complete the test. The Clear Test Log button will clear the contents
of the Test Log.
Error Log—Displays the tests that have failed during the diagnostic testing. Besides displaying the
device and test this section might also include error details. The description section describes the error
that the diagnostic test found. The Recommended Repair will give a recommended action that should be
performed to resolve the failed hardware. The error count is the number of times the test has failed. The
Clear Error Log button will clear the contents of the Error Log.
TEST COMPONENTS
Hardware and software tests can be performed on the following components:
Audio—Identifies all audio devices installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these devices.
CPU—Identifies all processors installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these devices.
Inspect—Captures general system configuration information.
Keyboard—Identifies the keyboard installed in a system and provides the ability to verify proper
operation of this device.
Memory—Identifies all memory modules installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these modules.
Modem—Identifies all modem devices installed in a system, captures any associated configuration
information, and provides the ability to verify the proper operation of these devices.
Mouse—Identifies the mouse installed in a system and provides the ability to verify proper operation
of this device.
Network—Identifies all network devices installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these devices. NIC testing is only
performed if drivers are installed during discovery.
Parallel Port—Identifies all parallel devices installed in a system and captures any associated
configuration information. If the parallel port is properly configured and the information is available to
the operating system, the associated DMA, IRQ, and I/O ports are reported. This test component also
provides the ability to verify proper operation of these devices.
PCI Bus—Identifies all PCI devices installed in a system and provides the ability to verify proper PCI
I/O operation to the devices.
Serial Port—Identifies all serial devices installed in a system, captures any associated configuration
information, and provides the ability to verify proper operation of these devices.
Storage—Identifies storage devices connected to a system through IDE, USB, SCSI, or a Fibre
Channel network. Supported devices include:
IDE hard disk drives
USB disk drives
SATA disk drives
HP INSIGHT DIAGNOSTICS OFFLINE EDITION 109