Removing and Replacing Mass Storage Devices
Section Contents
•
Removing the Mass Storage Module
•
Removal and replacement instructions for mass storage devices
•
Device addressing and location
Introduction
Instructions for removing and replacing Mass Storage Devices (internal) are in this sec-
tion. The procedures for all devices are the same. Devices include the following:
3.5-inch Flexible Disk Drive
Hard Disk Drives
CD-ROM Drive
DDS Tape Drive
Preliminary Requirements
Before you remove the Mass Storage Module perform the following:
1
Before system shut down is performed you should execute ioscan, and record the SCSI
addresses in-use.
2
Shut down any applications.
3
Shut down the Operating System.
4
Refer to the owner's guide, for information on properly shutting down HP-UX.
5
Turn off power to the Model 748.
6
Set up a static-free work place to handle the mass storage tray.
Removing and Replacing Mass Storage Devices
5-15