EISA or PCI Backplane Replacement
Preliminary Requirements
1
Remove the top cover using the procedure earlier in this chapter.
2
Remove the front bezel using the procedure earlier in this chapter.
3
Remove the mid-tray using the procedure earlier in this chapter.
Procedure
4
Remove any EISA or PCI cards from the chassis.
5
Remove the screws that hold the backplane assembly in the mid-tray. See Figure 5-27.
6
Slide out backplane assembly
Figure 5-27
7
Separate the backplane from the converter card by pulling the apart.
EISA or PCI Backplane Replacement
Backplane Assembly Removal
5-40