Table of Contents
Advertisement
6
From outside the PC, screw the nut back onto the coax connector until it is secured tightly
on the network board.
7
Replace the PC's cover.
8
Reconnect all cables and then the power supply cord.
INSTALLING MASS STORAGE DEVICES
You can install additional mass storage devices, if you need extra mass storage space for your
application software.
The PC has one internal drive shelf for a hard disk drive. If your PC already has a hard disk
drive, this shelf will be occupied.
There are three front access drive shelves. The top shelf is occupied by a 3.5-inch flexible disk
drive. The middle shelf can be used to install a 5.25-inch flexible disk drive or a CD-ROM
drive. The bottom shelf can be used to install a 1-inch high, 5.25-inch or 3.5-inch front access
device, or to install a second hard disk drive internally.
Your PC has the following connectors on the system board which can be used by mass storage
devices:
•
a flexible disk drive connector, which supports up to two flexible disk drives
•
two Enhanced IDE device connectors.
NOTE
You can install a non-IDE hard disk drive or CD-
ROM device, but it will need an accessory board and
driver software (usually supplied with the device).
Contact the product vendor for further information.
Advertisement
Table of Contents
