Removal And Replacement; Port Jack Screws - HP Model 745 - VME Workstation Handbook

Removal and Replacement

Follow these steps to remove the front panel:
1 Remove the interface port jack screws (There are two around each port - SCSI, video,
and so forth) using the appropriate 3mm (0.125-inch) or 4mm (0.160-inch) nutdriver.
The port jack screws are shown in Figure 5-12.
Port jack screws, 14 total, two each around seven of the ports.
Figure 5-12
2 Remove the two small screws, one on each underside front corner of the board, that fas-
ten the ejector handles to the board.
3 Pull the front panel forward, away from and off the system board.
4 Remove the RFI clip on the two RS-232 ports.
NOTICE:
Field Replaceable Units
Removing and Replacing the Front Panel

Port Jack Screws

To replace the front panel, reverse the steps for
removing the front panel extension panel.
5-22