On Board Dact - Fire-Lite MS-9200UDLS Manual

Programming

ON BOARD DACT

1=ENABLED
2=PRIMARY PHONE
3=SECONDARY PHONE
On Board DACT Screen #1
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=SUPERV PHONE LINE
On Board DACT Screen #2
134
To select the type, press 1 while viewing the Primary Phone Line screen. The following screen will
be displayed:
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 62/38
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33 or 3
to select Rotary dialing with a make/break ratio of 62/38.
Secondary Phone

Press 3 while viewing On Board DACT Screen #1 to program the type of secondary phone line\
being connected to the DACT. The following screen will be displayed:
1=TYPE
To select the type, press 1 while viewing the Secondary Phone Line screen. The following screen
will be displayed:
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 62/38
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33, or 3
to select Rotary dialing with a make/break ratio of 62/38.
Service Terminal

The FACP can be programmed remotely from a PC using a modem and telephone line.
Information can also be retrieved from the FACP using the same method. The Upload/Download
option allows an operator to set the necessary parameters to allow the uploading and downloading
of data between the FACP and PC. The Service Terminal selection provides the means for entering
these parameters.
PHONE LINE
Primary Phone Type Screen
ON BOARD DACT
SECONDARY PHONE LINE
TOUCHTONE
Secondary Phone Line Screen
PHONE LINE
Secondary Phone Type Screen
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Master Programming Level