Optional Module Installation
Receive lines. Apply power to the FACP and printer or PC. Note that a ground fault (zero imped-
ance to ground) may occur on the FACP, dependent on the printer or PC being used, due to this
connection. For this reason, it is important that there be no preexisting ground fault on the panel.
Note that the printer may or may not be supervised as determined by user programming. Refer
to"Printer/PC" on page 144.
Printer Configuration
Refer to the documentation supplied with the printer for pertinent information about printer setup.
Set the printer's options as listed in the following table:
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
PRT/PK-CABLE
Figure 2.17 Serial Printer and Computer Connections
COMMUNICATION SETUP
BUFFER:
DATA BITS:
PARITY:
STOP BIT:
BAUD RATE:
AUTOMATIC LINE FEED
AUTOMATIC CARRIAGE RETURN
Table 2.1 Printer Options
LARGE
7
EVEN
1 STOP
2400/4800/9600
NO
NO
Installation
59