Ann-I/O Options - Fire-Lite MS-9200UDLS Manual

Programming
If ANN-I/O, ANN-LED, or ANN-RLY is the selected module type, the following ANN-BUS
Address Screen will be displayed:
Since the options for each of these module types can be individually set, pressing 2 for Module
Options, while viewing the ANN-BUS Address Screen will display the available options as
described below.

ANN-I/O Options

Pressing 2 for Module Options while viewing ANN-BUS Address screen when the ANN-I/O
option is selected will display the following screen:
The first screen indicates that the ANN-I/O at ANN-BUS address 1 is programmed to annunciate
SLC Loop #1 addressable Detectors with addresses 1 through 30. The programming can be
changed using ANN-I/O Address Screens 2 and 3.
Pressing 1 while viewing ANN-I/O Address Screen #2 will program the annunciator module to
annunciate either Point (addressable device address) information or Zone information.
Pressing 1 while viewing ANN-I/O Address Screen #3 will select the Point or Zone range to be
annunciated (refer to the tables in "ANN-I/O Zone Option" on page 123 and "ANN-I/O Point
Option" on page 124).
Pressing 2 while viewing ANN-I/O Address Screen #3 will select either addressable detectors or
addressable modules to be annunciated.
122
ANN-BUS MODULE X-1
ANN-BUS ADDRESS
1=TYPE
2=MODULE OPTIONS
ANN-BUS Address Screen
ANN-I/O - ADDR X-1
LOOP1 DET 1-30
ACTIVE LEDS ONLY
ANN-I/O Address Screen #1
ANN-I/O - ADDR X-1
1=POINT/ZONE
ANN-I/O Address Screen #2
ANN-I/O - ADDR X-1
1=RANGE
2=DET/MOD
ANN-I/O Address Screen #3
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Master Programming Level
ANN-I/O