Initial Power-Up; Programming Screens Description; Programming And Passwords - Fire-Lite MS-9200UDLS Manual

Programming
Exit Programming, Read Status
The programmer can exit any mode by repeatedly pressing the keypad ESC (Escape) key until the
display reads System All Normal. Note that the data which is entered during Programming mode
is not saved until the programmer exits this mode by repeatedly pressing the 'ESC' key. If the Reset
key is pressed or power is lost before exiting Programming mode, all data just entered will be lost.
User Programming Levels
There are two user programming levels:
• User Master Program Level 1 is used for programming panel specific data relating to device
types, zoning, messages, control panel functions, etc.
• User Maintenance Program Level 2 is used by a qualified operator to access features such as
Disable/Enable, View and Clear History, Walktest and System Time Change.

3.3 Initial Power-up

The following sections describe the initial programming procedures for a new system. The same
procedures are used to modify programming in an existing system.
After completing the wiring of addressable devices to the SLC, apply power to the control panel. If
the addressable devices have not yet been programmed into the FACP, their LEDs will not flash and
the following trouble message will be displayed.

3.4 Programming Screens Description

The options available when the Enter key is pressed are: Read Status, Programming. The Read
Status and Programming options have multiple functions or features which may be chosen. To
view all of the choices, it is necessary that the programmer scroll through a number of additional
subscreens. These selections are displayed on multiple screens to make them more readable for the
programmer. Refer to "Master Programming Level" on page 64, for additional information on the
various screens.
The title of the main option screen will always be displayed at the top of the subscreens for the
programmer's convenience. If additional subscreens exist, an Up or Down arrow will be displayed
in the upper right corner of the screen being viewed. The programmer can then press the keypad
Up or Down arrow key to view the new subscreen. To select one of the choices in a screen, the
programmer presses the keypad numerical key corresponding to the desired choice.
Note that subscreens may also have multiple options which require viewing more than one screen.
The same process, as detailed in the previous paragraphs, is followed to view all option choices.

3.5 Programming and Passwords

There are two factory set programming passwords which will access the Programming screens as
indicated in the following examples. From either of the screens, access to specific system and
device features or programming may be obtained. All user programming entries are stored in
nonvolatile memory. The factory set passwords can be changed by the user as described in
"Password Change" on page 145. If an invalid password is entered, the blinking cursor will return
62
TROUBL IN SYSTEM
NO DEVICES INSTALLED
09:03A 012106
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Initial Power-up