Gs $ Nl Nh - Citizen PPU-700 Command Reference Manual

GS $ nL nH

[Function] Specifying the absolute vertical position of characters in PAGE MODE
[Code]
<1D>H<24>H<nL><nH>
[Range] 0≦nL≦255、0≦nH≦255
[Outline] Specifies the vertical position of character at the start point of data development in
PAGE MODE using absolute position based on the start position. The position of vertical
direction of character at the start position of next data development is the position [(nL
+ nH×256)×basic calculation pitch] from the start position.
[Caution] • This command is ignored except at PAGE MODE selection.
• Absolute position setting exceeding the specified print area is ignored.
• Position in horizontal direction of character at the start position of data development is
not shifted.
• Start point used as the reference is set by ESC T.
• The following operation occurs at the start point of ESC T.
• Basic calculation pitch is set by GS P.
• When fractional number is caused by the calculation, it is corrected by the minimum
pitch of mechanism and the rest is discarded.
[See Also] ESC
(1) When start point is set at upper left or lower right, the absolute position of paper
feed direction (vertical direction of character) is set. In this case, basic calculation
pitch (y) of vertical direction is used.
(2) When start point is set at upper right or lower left, the absolute position of
vertical direction of paper feed (vertical direction of character) is set. In this case,
basic calculation pitch (x) of horizontal direction is used.
$, ESC T, ESC W, ESC GS P, GS ＼
＼,
- 42 -