Command Line Access; Running The Group 1 Tests - 3Com EISA 10/100BASE-T User Manual

5-4 C
HAPTER
4 The first time you use the EtherDisk diskette, a license screen
appears. To accept the terms and conditions of the 3Com
end-user software license agreement, type the following:
Y
5 When the auto installation screen appears, as shown in
Figure 3-2, press [Enter].
6 When the main menu appears, select Configuration/
Diagnostic/Troubleshooting and press [Enter].
7 When the Configuration and Diagnostic screen appears, select
Configuration and Diagnostic Program, and press [Enter].
If you are testing multiple adapters, a screen displaying
descriptions of each installed adapter appears. Highlight the
adapter you want to test and press [Enter]. A screen appears,
showing the selected adapter.
8 Continue with the instructions given in the section

"Running the Group 1 Tests."

Command Line Access

You can also run the tests from the command line. At the
system prompt, type:
3C59XCFG RUN
Running the Group 1 Tests
To run the Group 1 tests, follow these steps:
1 Under the Test pull-down menu, select Run Tests. Press [Enter].
The Run dialog box appears, with the Start button highlighted.
2 Press [Enter] to start the tests.
Group 1 tests run ten times unless you specify otherwise. The
test results are displayed on the screen in the Results column.
5: P T
ERFORMING ROUBLESHOOTING AND
D T
IAGNOSTIC ESTS