Multiple Eisa Adapters In A Server - 3Com EISA 10/100BASE-T User Manual

Loading NetWare ODI Drivers
4-11
For complete details on loading the NetWare 4.x server driver
for your NetWare version, refer to the readme files, which are
in the \NETWARE\SERVER subdirectory on the EtherDisk
diskette. The readme files are named as shown below:
README.40X
README.41
README.311
README.312
2 When you start the server, enter the following commands:
For NetWare 3.11:
load C:LSLENH.NLM [Enter]
load C:3C59X.LAN PORT=XXXX [Enter]
bind ipx to 3C59x net=XXXX [Enter]
For NetWare 3.12, 4.0x, or 4.x:
load C:3C59X.LAN PORT=XXXX [Enter]
bind ipx to 3C59x net=XXXX [Enter]
where XXXX is the adapter's port address. (To determine the
port address, multiply the slot number by 1000 hex. If the
adapter is installed in slot number three, for example,
multiply 3 by 1000 hex = 3000 hex.)
If the load sequence above is not followed, the system will
not operate correctly.
When running the 3C59X.LAN driver with NetWare 3.11, you
must update the MONITOR.NLM file that accompanied
NetWare 3.11 with the MONITOR.NLM file from Novell. For the
latest NLMs, contact Novell.

Multiple EISA Adapters in a Server

If you are running NetWare and have installed multiple
adapters in an EISA computer that is functioning as a server,
follow the instructions in this section to install the NetWare 4.x
server driver.