Using Windows 95 - 3Com EISA 10/100BASE-T User Manual

4 Follow the on-line prompts and the instructions that
accompanied your EISA computer and then run the EISA
configuration utility.
The sequence of configuration steps required for some EISA
computers may vary from the steps explained here. Consult
the EISA configuration utility manual provided by the
manufacturer of your computer for more details.
5 When the EISA configuration utility asks for a .CFG file to
copy, remove the EISA configuration diskette.
6 Insert the EtherDisk diskette and press [Enter].
The configuration file !TCM5920.CFG is copied from the
EtherDisk diskette.
7 When the adapter has been successfully configured, follow
the displayed instructions to save and exit the program.
Then proceed to Chapter 4, "Loading Network Drivers."

Using Windows 95

If you are running Windows 95, after installing the adapter run
the EISA configuration utility program by following these steps:
1 Turn on the computer.
The computer will display a message notifying you that a
new hardware device (the 3Com EtherLink III EISA adapter)
has been detected.
The message asks you to run the system (EISA) configuration
utility.
Configuring the Adapter
3-3