Table of Contents
Advertisement
6 Repeat steps 3 and 4 for each adapter.
7 Exit the program.
NetWare Driver Installation
To install the 4.x server driver, follow these steps:
1 Copy the contents of the appropriate \NETWARE
subdirectory to the boot partition of the server's hard disk.
2 When you start the server, enter the following commands:
For NetWare 3.11:
load C:LSLENH.NLM [Enter]
load C:3C59X.LAN PORT=XXXX NAME=X [Enter]
load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
bind ipx to X net=XXXX [Enter]
bind ipx to Y net=XXXX [Enter]
For NetWare 3.12, 4.0, or 4.0x:
load C:3C59X.LAN PORT=XXXX NAME=X [Enter]
load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
bind ipx to X net=XXXX [Enter]
bind ipx to Y net=XXXX [Enter]
where XXXX is the adapter's port address. (To determine the
port address, refer to the previous section, "Finding the
Adapter's Port Address for Multiple Adapters.") The NAME=X
and NAME=Y parameters that you assign help distinguish the
multiple adapters.
If the load sequence is not followed, the system will not
operate correctly. Make sure that the PORT XXXX parameter
is entered for all adapters.
When running the 3C59X.LAN driver with NetWare 3.11, you
must update the MONITOR.NLM file that accompanied
NetWare 3.11 with the MONITOR.NLM file from Novell.
For the latest NLMs, contact Novell.
This concludes the procedure for installing multiple adapters
in an EISA computer functioning as a server.
Loading NetWare ODI Drivers
4-13
Advertisement
Table of Contents
