Changing The Settings; Auto Installation Screen; Main Menu - 3Com EISA 10/100BASE-T User Manual

3-6 C
HAPTER

Changing the Settings

To change the software option settings, follow these steps:
1 Make sure the Fast EtherLink EISA adapter has been properly
installed in your computer, as explained in Chapter 2,
"Installing the Hardware."
CAUTION: If this computer is an operating server, notify all
users of the server to save their work and log out from the
network before you begin. The EtherDisk diskette Configuration
and Diagnostic Program disrupts the normal operation of
servers and workstations, so work that is not saved may be lost.
2 Boot your computer under DOS, version 3.1 or later.
3 Place the EtherDisk diskette in a floppy drive on your
computer and make that drive the active drive. For example:
A: [Enter]
4 At the prompt, type:
INSTALL [Enter]
5 The first time you use the EtherDisk diskette, a license screen
appears. To accept the terms and conditions of the 3Com
end-user software license agreement, type the following:
Y
6 When the Auto Installation screen appears, as shown in
Figure 3-2, press [Enter].
7 When the main menu appears with a list of options, as
shown in Figure 3-3, select Configuration/Diagnostic/
Troubleshooting.
8 When the Configuration and Diagnostic screen appears,
select Configuration and Diagnostic Program.
3: C
ONFIGURING THE
A
DAPTER