Multiple Nics In A Server - 3Com TokenLink 3C339 User Manual

To install the NetWare server driver while running
NetWare 3.12 or 4.x, follow these steps:
1 Determine the NIC's port address, as described
in "Finding the NIC's Port Address" earlier in this
chapter.
2 Before starting the server, copy the contents of the
appropriate directory on TokenDisk diskette #1 to
the boot partition of the server's hard disk:
3 Start the server and enter the following command
at the server prompt:
load C:3C3X9.LAN PORT=XXXX
where XXXX is the NIC's port address.
4 Bind the appropriate transport protocol to the
NIC name.
Add the load and bind commands to the AUTOEXEC.NCF
file for automatic execution when you start or restart
the server.
This concludes the procedure for installing the NetWare
server driver for one NIC in a server with NetWare 3.12
and 4.x.

Multiple NICs in a Server

If you are running NetWare and have installed multiple
NICs in a computer that is functioning as a server, follow
the instructions in this section to install the driver.
Before installing the driver, see "About Installing on a
NetWare Server" earlier in this chapter for important
information about NetWare Loadable Modules.
For NetWare 3.12, use the \NETWARE\SERVER\3.12
directory.
For NetWare 4.x, use the \NETWARE\SERVER\4.X
directory.
Installing NetWare Drivers 3-9