Changing Configuration Settings - 3Com Server User Manual

5-2 C
HAPTER
Changing Configuration Settings
You can use the Configuration and Diagnostic Program to
change configuration settings.
Table 5-2
through the Configuration and Diagnostic Program.
Table 5-2 Using the Configuration and Diagnostic Program
Task
To select buttons
To select other items
To escape a screen
To get help
Follow these steps to change configuration settings:
1 Make sure that the NIC is installed and connected to
the network, as described in
2 Boot the PC under DOS.
The Configuration and Diagnostic Program is a DOS
application. It must be run in DOS, not in a DOS window.
It will not run if memory managers or other device drivers
have been loaded.
3 Insert the 3Com diskette in the drive and make that
the active drive.
4 Enter this command at the DOS prompt to start the
Configuration and Diagnostic Program:
3c395cfg
5 From the Install menu, select a NIC as follows:
The parameters for the selected NIC are displayed.
6 Select options and select settings.
For information on how to select items and move through
the program, see
setting, select it and press F1.
5: C
ONFIGURATION
summarizes how to select items and move
If one NIC is installed, select Configure Adapter.
If more than one NIC is installed, select the NIC that you
want to configure.
Table
Action
Press Tab and then press Enter.
Use the arrow keys, and press Enter.
Press Esc.
Select an item and press F1.
Chapter
5-2. To get Help on an option or a
2.