Setup Of The Recorder; Confirming The Midi Clock Sync - Fostex D2424LV Reference Manual

Model D2424LV Reference Manual (MIDI Sync Function)
• Setup of the D2424LV
1. Because the MIDI clock and song position pointer will be output from the recorder, set the SETUP mode
"MIDI sync signal output setting" to "CLK."
* Initial setting:
* Permissible setting:
* This item can be setup for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page " 114 ", SETUP mode "MIDI sync signal output setting" for correct operating procedures.
2. The meter in the desired bar can be set by "Time signature setting" of the SETUP mode.
* Initial setting:
* Permissible bar setting:
* Permissible meter setting:
* Permissible setting of maximum number of points:
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page " 109 ", SETUP mode "Time Signature Setting" for operating procedure.
3. Tempo in the desired bar can be set by "Tempo setting" of the SETUP mode.
Tempo map is made in steps 2 and 3.
* Initial setting:
* Permissible bar setting:
* Permissible signature setting:
* Permissible setting of tempo:
* Permissible setting of maximum number of points:
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page " 111 ", SETUP mode "Tempo Setting" for operating procedure.
4. Set the SETUP mode "Metronome setting" to ON if click sound is to be output according to the setup
tempo map.
* Initial setting:
* Permissible setup item:
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page " 112 ", SETUP mode "Metronome setting" for operating procedure.
5. Press the [DISP SEL] key while holding down the [SHIFT] key, and then change the time base display to
BAR/BEAT/CLK.

• Confirming the MIDI clock sync

During recording and at playback following the recording, the time base (BAR/BEAT/CLK) is
displayed in accordance to the setup tempo map, and the MIDI clock and song position pointer
is also output.
Confirm that the travel position (BAR/BEAT/CLK) of the recorder and the travel position of the
synchronized MIDI sequencer are matched.
MTC
CLK (MIDI clock and song position pointer:"CLK")
MTC (MIDI time code: "MTC")
Off (No output of MIDI sync signal)
001 bar, 4/4 signature.
001~999
1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8,
— — (Elimination of signature)
64 points
001 bar, 1st meter, Tempo120.
Follows the previous "Setup of the time signature."
Follows the previous "Setup of the time signature."
Quarter note=30~250 .... (Tempo elimination)
64 points
Off
Off, On
78