Loading The Data Using A Adat Or S/P Dif Digital Signal; Connecting The External Device; Setting Up An External Device; Executing The Load Operation - Fostex D2424LV Reference Manual

Loading the data using a adat or S/P DIF digital signal

Load the data by S/P DIF digital signals (or adat digital signals) from the [DATA INPUT] connector of
the recorder.
* Restore the initial settings on the recorder.
* Set the same sampling rate on the external digital device and the recorder.

Connecting the external device

Connect [DATA INPUT] connectors of the recorder to the digital output connectors on the external digital
device.
<Notes>
• The recorder has [DATA INPUT] connectors for an S/P DIF digital signal (OPTICAL) and for an adat digital signal.
These connectors have the same shape but carry different information.
Use the [DATA INPUT] 1-8 connector. Do not use the [DATA INPUT] 9-16 and 17-24 connectors.
• Do not remove the optical cable or perform any other operation that would disconnect the S/P DIF signal until
the session is complete. Otherwise, the recorder will generate noise, and affect the connected device.
[DATA INPUT] 1-8
• If the external device has only COAXIAL type (RCA) digital I/O connectors, connect an optional COP-1/96k (optical/
coaxial converter) to use an S/P DIF digital signal.
• Connecting both output and input connectors on the recorder to the input and output connectors on the external
digital device respectively may generate a digital loop.

Setting up an external device

1.Setup the external device so that it can output a digital signal.
2.Locate the beginning of the pilot signal recorded in the saved data.
* Refer to the instruction manual that came with your external digital device for details.

Executing the load operation

You will use the "Load PGM ?" menu in Setup mode.
• Input format available
• Programs available
• Track available
Model D2424LV Reference Manual (Saving and Loading Song Data)
: adat, SPDIF, SCSI, IDE2
: When using an adat/SPDIF -> P01 - P99 (each program individually)
: When using a SCSI/IDE2
: When using an adat or DAT-> Tracks 1-8, 1-16, 1-24, 1-32, 1-40, 1-48,
1-56, 9-16, 9-24, 9-32, 9-40, 9-48, 9-56, 17-24, 17-32, 17-40, 17-48, 17-56
25-32, 25-40, 25-48, 25-56, 33-40, 33-48, 33-56, 41-48, or 49-56
: When using a SCSI/IDE2
selected.
-> P01 - P99 or All program
-> All tracks (1-56) will be automatically
91
adat or DAT
adat Out (or Digital Out)