Setting A Preroll Value - Fostex D2424LV Reference Manual

Model D2424LV Reference Manual (Changing the Initial Settings <SETUP mode>)
The recorder features the Preroll function that enables you to locate a position a few seconds prior to a
specified locate point. The "Setting a preroll value" menu allows you to set the preroll time (in seconds).
The Preroll function is convenient when you wish to monitor the audio data from a point slightly before the
locate point.
This point is located if the current position is before the locate point.
Setting a preroll time
1.While the recorder is stopped, press the [SETUP]
key to enter SETUP mode.
2.Turn the Jog dial to select "Preroll Time ?" ("?"
flashes.), then press the [EXECUTE/YES] key.
The current preroll time setting appears on the display.
Pressing the [EXECUTE/YES] key lights up the flashing
"?" character steadily; the current setting flashes.
The initial setting is "00" as shown below.
SETUP
OL
0
3
6
9
12
18
24
30
42
1 2 3 4 5 6 7 8 9 10 11
SETUP
OL
0
3
6
9
12
18
24
30
42
1 2 3 4 5 6 7 8 9 10 11
3.Turn the Jog dial to enter a desired preroll time
value.
You can set a value in one-second increments.
Rotating the Jog dial clockwise increases the value, and
rotating it counter-clockwise decreases the value.
Setting a preroll value ("Preroll Time ?" menu)
• Initial setting:
• Setting range of preroll time:
* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
This point is actually located.
S
OL
BIT
0
3
6
9
12
18
24
30
42
12 13 14 15 16 17 18 19 20 21 22 23 24
Flashing
S
OL
BIT
0
3
6
9
12
18
24
30
42
12 13 14 15 16 17 18 19 20 21 22 23 24
[00] second
[00] - [10] seconds in one second steps
Preroll time (before the locate point) can be set between 00 and 10 seconds.
This point is located if the current position is after the locate point.
Locate point (stored in the memory key).
4.Press the [EXECUTE/YES] key.
The display shows the value, then returns to the
indication that appeared in step 2.
To cancel the setting operation, or to restore the
setting obtained prior to the [EXECUTE/YES] key press,
press the [STOP] button or the [EXIT/NO] key. Each
time you press one of these keys, the recorder returns
to the previous hierarchy level of the menu, and
finally exits SETUP mode and displays the previous
Time Base.
24
FS
kHz
CLOCK
INT
24
FS
kHz
CLOCK
INT
113