Brother PE-Design Next Instruction Manual page 66

Reshaping Embroidery Patterns
To Smooth
To Symmetry
To Cusp
3.
Drag the path to adjust it.
b
Memo:
The shape can be changed by dragging the
handles for the point on the curve.
Moving entry/exit points
and the center point
■
Moving the entry/exit points
1.
Select the Entry/Exit/Center Point tool by
clicking 1, then 2, then 3.
1
2
3
64
2.
Click the object.
This is the entry point for the outline
stitching. The previous pattern is
connected to this point.
This is the exit point for the outline
stitching. Stitching continues from this
point to the next pattern.
This is the entry point for the inside
region stitching. The previous pattern
is connected to this point.
This is the exit point for the inside
region stitching. Stitching continues
from this point to the next pattern.
3.
Drag the arrow for the point to the desired
location on the outline.
b
Memo:
• If the outline or the inside region are set to
not be sewn, the corresponding point does
not appear.
• If the region has the concentric circle stitch
or radial stitch applied, the center point of
the stitching also appears.
c
"Moving the center point" on
page 65.
a
Note:
• Only entry and exit points for patterns
created with the Circle or Arc, Rectangle
and Line/Region tools can be edited.
Stitch pattern or patterns created with the
Text tools or Manual Punch tools cannot
be edited.
• If the entry and exit points have been
optimized, the entry and exit points of the
patterns cannot be edited. In order to use
this tool for editing the entry and exit
points, Optimize Entry/Exit points must
be canceled.