Brother PE-Design Next Instruction Manual page 156

Tutorial 9: Creating Appliqués
3
Select the two patterns, and then click 1, then
2, then 3 to apply hole sewing.
1
2
3
c
"Hole sewing" on page 45.
4
Select the outer circle.
a
Note:
Be sure to select the outer pattern before
starting the Applique Wizard.
Step 2 Using the Applique Wizard
1
Click 1, then 2.
1
2
2
Specify the desired settings in the Applique
Wizard.
(1) (2)
(5)
(1) Applique Material: Select whether (Yes)
or not (No) the outline of the appliqué is to
be sewn onto the appliqué fabric as a
guide for cutting it out.
(2) Applique Position: Guideline for
attaching the appliqué piece is set to be
sewn automatically.
154
(3) (4)
(3) Tack down: Select whether (Yes) or not
(No) the appliqué is to be basted onto the
base fabric. If Yes is selected, you also
select which stitch (Satin Stitch, E Stitch
or V Stitch) to use for the basting.
Satin Stitch E Stitch
(4) Covering Stitch: Select the sew type and
other attributes (Width and Density) for
finishing the appliqué.
(5) Create an applique with hole sewing:
Select this check box when creating an
appliqué with holes (empty regions).
(This check box appears only when an
outer pattern with hole sewing applied
was selected.)
For this tutorial, we will select the Create an
applique with hole sewing check box.
All other settings will remain unchanged.
3
Click OK.
b
Memo:
The appliqué is indicated by diagonal lines as
shown below.
When the "Create an applique with
hole sewing" check box is cleared
When the "Create an applique with
hole sewing" check box is selected
V Stitch