Brother PE-Design Next Instruction Manual page 302

Sewing attributes
■
If the entry/exit points of sewing have been changed
If the entry/exit points of line sewing with the motif stitch, stem stitch or candlewicking stitch have been
changed or optimized, select a setting for Start/End Type in the line sewing attributes.
c
"Start/End Type" on page 297 and "Moving entry/exit points and the center point" on page 64
If Feed was selected under Start/End Type, jump stitches are entered at the beginning or end of pattern
stitching (with a motif stitch, stem stitch or candlewicking stitch). If Run was selected under Start/End Type,
running stitches following the path are entered at the beginning of and between pattern stitching.
a
Note:
• After changing the Start/End Type, check the stitching with the stitch simulator.
c
"Checking the stitching with the Stitch Simulator" on page 71
• Embroidery patterns where the Start/End Type of line sewing with the motif stitch, have been changed or
optimized in an application earlier than version 8 are opened or imported with this stitching specified as jump
stitches.
300
Before the entry/exit points are changed
Entry point/Exit point
When the entry point is moved
Feed
Exit point
Run
Exit point
Path of actual stitching
Entry point
Jump stitch
Entry point
Running stitch