Tutorial 10-3: Embroidering With The Jumbo Frame - Brother PE-Design Next Instruction Manual

Tutorial 10-3: Embroidering With the Jumbo Frame

Tutorial 10-3: Embroidering With the
Jumbo Frame
This section describes the procedures for creating embroidery data and for embroidering using the jumbo
frame (frame size: 360 × 360 mm; with mounts on both sides of the embroidery frame).
a
Note:
• If the jumbo frame was selected, the size of the Design Page
becomes 350 × 350 mm in order to create margins that allow
automatic positioning using the built-in camera.
• The jumbo frame described here was designed specifically for
our multi-needle embroidery machines equipped with a built-
in camera. It cannot be used with any other machine, such as
single-needle embroidery machines. Check the Operation
Manual provided with your multi-needle embroidery machine
to determine if it is compatible with the jumbo frame.
b
Memo:
For details on embroidering using the camera and on affixing
the embroidery positioning stickers, refer to the Operation
Manual provided with the embroidery machine.
Sample data that can be used in this example is provided in the following folder.
Documents (My Documents)\PE-DESIGN NEXT\Tutorial\Tutorial_10
Step 1 Selecting the Design Page size
Step 2 Creating the embroidery design
Step 3 Checking a divided pattern
Step 4 Attaching stabilizer to the fabric
Step 5 Embroidering
Step 1 Selecting the Design Page
size
1
Click 1, then 2.
1
2
2
Click under Machine Type (3), select
360 × 360 mm (Jumbo Frame) from the
Hoop Size selector under Page Size (4), and
then click OK (5).
166
Jumbo frame: 360 × 360 mm embroidery frame
a
Note:
Check the size of embroidery frames that
can be used with your machine before
changing the setting.
3
4
5