Replace The Staple Cartridge Of The Stapler Unit (Staple N1) - Canon AK1 Operation Manual

Replace the staple cartridge of the stapler unit (Staple
N1)
Introduction
When a staple cartridge of the stapler unit inside the stacker/stapler is empty, the control panel
will display a message indicating which staple cartridge must be replaced. The procedure below
describes how to replace the staple cartridge.
Required staples
Staple N1
NOTE
You can order all required supplies from your local authorized dealer.
Replace the staple cartridge of the stapler unit
Step Action
1 Open the front door of the stacker/stapler.
2 Grab the green tab of the staple case and
pull the staple case out of the staple unit.
3 Pull out the staple cartridge.
4 Insert the new staple cartridge (Staple
N1).
Canon Finisher-AK1/Saddle Finisher-AK2/Puncher Unit-BT1/BU1
Operation Guide Finisher-AK1, Saddle Finisher-AK2, Puncher Unit-BT1-BU1: VarioPrint (VP) 110, VP120, VP135 - Edition 2013-06
NOTE
When the stapler unit is at the
back and it is difficult to pull out
the staple case, turn the dial at
the bottom left-hand side to the
left to move the stapler unit.

Replace the staple cartridge of the stapler unit (Staple N1)

Illustration
Chapter 3 - Use the stacker/stapler
4
23