4
Set the DIP switches.
Set the DIP switches with the tip of a ball-point pen etc. For details on methods
for setting the DIP switches, see the table of p. 6-40.
5
Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board while
aligning it with the guide rails inside the expansion slot.
IMPORTANT
Do not touch the network board parts, printed wire, or connectors with your hands.
•
Insert the printer connector of the network board securely into the connector inside
•
the expansion slot.
6
Secure the top and bottom portions of the network board with
the two screws supplied with the network board.
7
Connect the LAN cable.
8
Connect the power cord.
9
Plug the power plug into the AC power outlet.
10
Connect the USB cable as needed.
1 0 0
L N K
E R R
C 1
N B -
DIP switches
ON
1
2
3
4
OFF
OFF
Network Board
6
6-41