Canon LASER SHOT LBP3500 User Manual page 369

12
6
6-38 Network Board
Make sure that the LNK indicator (green) on the network
board is on.
If the network board is connected by 10BASE-T, the board is working properly
when the LNK indicator is on.
If the network board is connected by 100BASE-TX, the board is working properly
when the LNK indicator and 100 indicator are on.
((A): ERR Indicator (B): LNK Indicator (C): 100 Indicator)
(A)
(B)
(C)
If the network board is not working properly, turn the printer OFF, and then check
the LAN cable connection, hub performance, and network board installation.
IMPORTANT
When you use this printer with the network board installed, the firmware version of
the network board needs to be 1.30 or later. Otherwise the printer does not operate
properly. Make sure that the firmware version is 1.30 or later after installing the
network board and the CAPT software. If the version is not 1.30 or later, update the
firmware of the network board using the update file in the "NB-C1_Firmware" folder
in the CD-ROM supplied with the printer. If you do not update the firmware, the
printer does not operate properly.
For details on the procedures for checking and updating the firmware version, see
the README file in the "NB-C1_Firmware" folder.
You can also download the firmware update file from the Canon website.