Motor Assy Dup; Holder Assy Ctd - Brother HL-4000CN Service Manual

2.2.18

Motor ASSY DUP

1) Release the hook securing the gear roll to the shaft of the roll exit.
2) Remove the gear roll from the shaft of the roll exit.
3) Release the hook securing the gear roll to the shaft of the roll MID from the chute
ASSY exit.
4) Remove the gear roll from the shaft of the roll exit.
5) Remove the gear 40/42 from the left side of the chute ASSY exit.
6) Remove the gear 48 from the left side of the chute ASSY exit.
7) Remove 2 screws securing the motor ASSY DUP to the chute ASSY exit.
8) Remove the motor ASSY DUP from the chute ASSY exit.
Gear roll: exit
Gear roll: MID
Gear 40/42
Gear 48
Screw, M3x6
2.2.19

Holder ASSY CTD

1) Release the 4 hooks securing the holder ASSY CTD to the front ASSY in.
2) Raise the holder ASSY CTD slightly from the front ASSY in and pull out the
connector.
3) Remove the holder ASSY CTD from the front ASSY in together with the spring CTD.
4) Remove the spring CTD from holder ASSY CTD.
Front ASSY in
Spring CTD
Fig.4-44
Holder ASSY CTD
Fig.4-45
IV-29
Motor ASSY DUP
Chute ASSY exit
Spring CTD