Feeder Assy Unit - Brother HL-4000CN Service Manual

2.5.3

Feeder ASSY unit

1) Push the shaft of the link actuator secured to the actuator no paper from the printer
feeder and disconnect the actuator no paper from the shaft.
2) Pull the link actuator from the hole in the printer feeder and remove.
3) Remove the connector connecting the printer and feeder ASSY unit from the left
side of the printer.
4) Remove the 2 connectors connecting the printer and feeder ASSY unit from the
right side of the printer.
5) Remove 8 screws securing the feeder ASSY unit to the printer.
6) Remove 4 long screws securing the feeder ASSY unit to the printer.
The top unit of the printer should be raised up by more than two people.
Note:
When removing the top unit of the printer from the feeder ASSY unit, be careful not to
drop or damage the upper part of the printer.
7) Raise the printer and separate it from the feeder ASSY unit, taking care not to
damage the cables.
Note:
Take care not to trap the harness on the feeder ASSY unit, when replacing the printer top
unit on the feeder ASSY unit.
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x10
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x10
Fig.4-100
IV-60
CAUTION
Screw, M3x10
Feeder ASSY unit
Screw, M3x10
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x10
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x10