Plate Assy Bottom Msi - Brother HL-4000CN Service Manual

6) Pull off the bush MSI on the shaft MSI toward the inside.
7) Raising the right end of the shaft ASSY roll feed, pull out the shaft ASSY feed from
the chute ASSY out.
Note:
When refitting the cam MSI ensure that it is located connecting on the shaft.
When refitting the stopper sol cam, ensure it is in the home position.
2.2.14

Plate ASSY bottom MSI

1) Remove 2 screws securing the plate out MSI to the chute ASSY out.
2) Remove the plate out MSI from the chute ASSY out together with the plate ASSY
bottom MSI.
3) Remove the plate ASSY bottom MSI from the plate out MSI.
Shaft ASSY roll feed
Bush MSI
Fig.4-39
Plate ASSY bottom MSI
Screw, M3x10
Plate out MSI
Right
Fig.4-40
Front
IV-25
Bush MSI
Screw, M3x10
Left