Brother HL-4000CN Service Manual page 149

6) Remove the ring E on the right and left shaft pivot securing the bottom portion of the
chute ASSY out and front ASSY in.
In the following steps, take care not to hurt your hand with burrs of the plate ASSY
bottom MSI.
7) Pull out the left shaft pivot from the chute ASSY out inward with radio pliers.
8) Pull out the right shaft pivot from the chute ASSY out inward with radio pliers.
9) Release latch A and pull the chute ASSY out complete with front ASSY in forwards to
remove them from the printer.
10) Remove the strap connecting chute ASSY out to front ASSY in.
Ring E
Shaft pivot
11) Release latch B to separate the front ASSY in from the chute ASSY out.
Chute ASSY out
CAUTION
Fig.4-24
Front ASSY in
Fig.4-25
IV-17
Ring E