Peco Performance PRO T4522-001 Quick Start Manual

AN ASTRONICS COMPANY
1
SeT clocK, Year, MonTH, daY
1. Press ▲/ ▼ to select 12 or 24 Hr mode, then
press Next.
2. Press ▲/ ▼to select clock hour, then press Next.
3. Press ▲/▼to select clock minutes, then press
Next.
4. Press ▲/ ▼ to select clock year, then press Next.
5. Press ▲/ ▼ to select current month, then press
Next. note: (month) appears.
Mo
6. Press ▲/ ▼to select current date.
note: appears.
Days
7. Press to fi nish clock mode.
Done
2
acceSS Service MenuS
1. Hold lower right and lower left keys
for fi ve seconds.
2. Press or
Next Go Back
Service Menu.
3. Press ▲/ ▼ to select Menu option.
4. Press when complete.
Done
© COPYRIGHT 2014 PECO ASTRONICS. ALL RIGHTS RESERVED.
button to select a
PERFORMANCE PRO T4000
3
configure Service MenuS
The following Service Menus (SM) commonly require
confi guration. Please verify that these are set for your
specifi c application. additional confi guration may be
required. refer to Table 2 for all available Service Menus.
• SM 100 = Programmable or nonprogrammable
• SM 110 = System Type
• SM 120 = fan control
• SM 130 = reversing valve
• SM 240 = number of Program Periods
• SM 260 = Temperature format (°f or °c)
• SM 340 = Keypad lockout
4
Wiring: TerMinal deSignaTionS
1. connect wires for appropriate system type
(Table 1).
▲
!
WARNING: DISCONNECT POWER BEFORE BEGINNING INSTALLATION.
• CAUTION: Use copper wire only. Insulate or wire-nut all unused leads.
• Use care to avoid electrostatic discharge to thermostat
• CAUTION: Do not connect unused wires together
• ALL ELECTRICAL LOADS MUST BE CONNECTED TO TERMINAL C
(24 VAC).
Table 1. TerMinal blocK deSignaTionS
Conventional
C 24 VAC, Unswitched side
W1 Stage 1 Heat
W2 Stage 2 Heat
G FAN
A
E
Y1 Stage 1 Cool
Y2 Stage 2 Cool (or Dehumidify)
24 VAC Power for heating,
RH
switched side
24 VAC Power for cooling,
RC
switched side
SC Sensor Common
S1 Indoor Remote Sensor
S2 Occupancy Sensor
1
QUICK START GUIDE
Heat Pump
C 24 VAC, Unswitched side
B/O Reversing Valve
AUX Auxiliary Heat (Stage 3 Heat)
G FAN
A
E
Y1 Compressor Stage 1, Heat/Cool 1
Compressor Stage 2 Heat/Cool 2
Y2
(or Dehumidify)
24 VAC Power for heating,
RH
switched side
24 VAC Power for cooling,
RC
switched side
SC Sensor Common
S1 Indoor Remote Sensor
S2 Occupancy Sensor
P/N 70930 3220-2322 REV 00