Setting Up The System; Network Connection; Local Connection - Olivetti d-Color MF201 Manual

2
2.3

Setting up the system

In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the fax driver onto the computer
being used.
!
Detail
This manual describes the setup method of network connection only for Port9100 that will be installed
by the installer, and LPR/Port9100 that will be installed by Add Printer Wizard printing.
For installation procedures via other network connections, refer to the User manual – Print Operations.
2.3.1

Network connection

1
Connect this machine to a computer.
2
Make sure the computer is connected to the network.
3
Specify the IP address of the machine to connect it to the network.
4
Depending on the connection method and protocol, change the network settings of this machine.
– LPR: Enable the LPD settings with the software switch (mode 384).
– Port9100: Enable the port setting with the software switch (mode 384), and specify the RAW port
number (default setting is "9100") in "Network Settings".
5
Install the fax driver.
– Specify the network port of the fax driver according to the connection method and protocol.
2.3.2

Local connection

1
Connect this machine to a computer
2
Install the fax driver.
!
Detail
For details on connecting this machine to a computer, refer to the User manual – Print Operations.
To update an existing fax driver, delete the existing fax driver first. For details, refer to "Uninstalling the
fax driver" on page 3-15.
2-6
Overview
d-Color MF201