Table of Contents
Advertisement
2
CONNECTIONS
Power Connection to Projector
AC Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector.
'Ã ƒr … vƒ ur … h y†
$ % ÃC “
POWER / MAINS
C OMM. P OR T
Power Check
The power voltage is autoranging between 100V (-10%) and 240V (+6%).
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the software setup.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
&$ ÃPu€
POR T 1
5976227 BARCOCINE 8 13042000
& $ÃPu €
P ORT 4/5
PORT 2
P ORT 3
,QRP
2))
)UHT
PO W ER
/ M A INS
PROJECTOR MODE
&$ÃP u€
P ORT 1
PROJECT OR MODE
&$Ã6 € ƒ
$%ÃC “
Connections
2-1
Advertisement
Table of Contents
